Our Facilities

Energy and Automotive Research Center

The Advanced Energy and Combustion Group is located at the Energy and Automotive Research Lab, which is a 40,000 square foot facility in the south wing of MSU’s Engineering Research Center.

In addition to the Rapid Compression Machine and Constant Volume Combustion Vessel, the lab contains optical engines and dynamometer facilities, laser diagnostic hardware, and cameras for high-speed combustion and flow visualization. The lab also uses commercial simulation and design software such as WAVE, Fluent, StarCD, CHEMKIN, CONVERGE CFD, and CASE.

MSU also has a High Performance Computing Center (HPCC) at ICER, the Institute for Cyber Enabled Research, which the research group can access for combustion simulations.

View on MSU Campus Map
Energy and Automotive Research Lab Building

Constant Volume Combustion Chamber (CVCC)

The MSU Constant Volume Combustion Vessel is a 22.24-liter, optically accessible cylindrical stainless-steel combustion chamber, designed and constructed by the research group for laminar flame speed measurements. In order to minimize the confinement effect and to improve the fidelity in the extraction of the laminar flame speed from the spherically expanding flames, the inner diameter and height of the cylindrical vessel were both chosen to be 30.48 cm. Two fused quartz windows, each 20.32 cm in diameter, are clamped on opposite sides of the vessel and permit optical observation of the spherical flame front up to a radius of 7.62 cm using a Z-type schlieren system.

  • High-speed Schlieren visualization
  • Characterization of Laminar Flame Speeds

Rapid Compression Machine (RCM)

RCMs are commonly used for homogeneous chemical kinetics studies at engine relevant pressure-temperature conditions. A typical RCM uses the mechanical stroke of a piston to generate high temperature and pressures for combustion, with many variations designed that have different mechanisms for rapid acceleration and deceleration of the piston. The MSU rapid compression machine is pneumatically driven and hydraulically stopped by an optimized pin and groove mechanism. The combustion chamber is 2 inches in diameter and provides optical access through side windows (0.5 inches in diameter) and a larger 2-inch end window, which provides a full view of the chamber. The RCM incorporates a creviced piston to reduce complex fluid mechanics and near-wall mixing within the combustion chamber, thereby improving the post-compression temperature distribution and achieving a homogeneous core region and accurate characterization of mixture temperatures for kinetic studies. The compression ratio of the MSU RCM can be varied from 6 to 18 in the current setup. A fuel injector or ignition system can be mounted on the top of the combustion chamber, leaving the side and end windows available for optical access.

  • Engine-relevant end-of-compression temperatures and pressures
  • Optical access for TJI and ignition visualization
  • Ignition delay time measurement